EYE SPEED® HD


  • Superior signal integrity with HyperTransport HT3.1 performance
  • Industry's densest I/O cable system
  • Rugged latching system
  • Shielded for EMI protection
  • Cable, connector, and cage available
  • Rugged design

EYE SPEED® HD ÜRÜN SERİLERİ

HDLSP

HDLSP
HDI6

HDI6
HDC

HDC

EYE SPEED® I/O


Samtec’s Eye Speed® I/O two piece system achieves high cycles and the 0.80 mm pitch connector design minimizes PCB real estate. The equalized cable option provides a performance boost to existing systems, without the expense of altering the board.

PASSIVE EQUALIZATION


Equalized cables are beneficial in systems where equalization was not implemented into the chip. They are a simple way to upgrade existing systems without the expense of altering the board.

The equalized option is an ideal middle-ground solution for applications where traditional copper cables are inadequate, but an expensive optical upgrade is unnecessary.

EQUALIZED PERFORMANCE


Performance improvements include:

  • Usable length increased 20 - 35% with equalization
  • Usable data rate increased 20 - 30% with equalization
  • Reduced jitter and improved bit error rate


Eye Speed® I/O - Max Data Rate
Eye Speed® I/O - Max Cable Length
Cable LengthUnequalizedEqualized
Data RateUnequalizedEqualized
1 meter21.0 Gbps25.5 Gbps
14 Gbps80" (2.032 mm)112" (2.845 mm)
3 meters9.5 Gbps13.0 Gbps
28 Gbps0" (0.0 mm)20" (0.508 mm)

SPECIFICATIONS


  • Performance to 25.5 Gbps for equalized cable (1.00 m)
  • Equalized option increases usable cable length and data rate
  • Small form factor for space saving applications
  • Micro rugged latching system
  • Shielded housing for EMI protection or sealed cable for IP68 applications
  • Supports SAS, SATA, Fibre Channel, Ethernet, PCIe® and InfiniBand™ protocols
  • High reliability Edge Rate® contacts

FIREFLY™ MICRO FLYOVER SYSTEM™


FireFly Micro Flyover System™ is the first interconnect system that gives a designer the flexibility of using micro footprint high-performance optical and low-cost copper interconnects interchangeably with the same connector system.

Samtec FireFly copper and optical cable systems provide the flexibility to achieve higher data rates to 28 Gbps and/or greater distances, simplifying board design and enhancing performance.


The system’s miniature footprint allows for greater density and closer proximity to the IC, enabling chip-to-chip, board-to-board, on-board and system-to-system connectivity.

PCIE® OPTICAL CABLE SYSTEM


  • Four independent, full-duplex optical channels
  • PCIe® x4 and x8 form factors
  • Supports Gen 1, Gen 2 and Gen 3 data rates
  • Lightweight 3.00 mm diameter cable up to 300 meters
  • Full active optical cables with host and target
  • Half active optical cables with MTP end option
  • Direct replacement for passive or active copper cables
  • Supports PCIe® auxiliary signaling (CPWRON, CPERST#, CPRSNT#, CWAKE#)
  • Sideband support
  • PCIEA Series adaptor card is recommended to mate with Samtec's PCIEO Series assembly
  • iPass™ form factor (iPass™ is a trademark of Molex Incorporated.)
  • Gen 3 speed up to 100 meters
  • Lightweight 3 mm diameter cable
  • Supports PCIe® auxiliary signaling (CPWRON, CPERST#, CPRSNT#, CWAKE#)
  • Male or female MTP optical connector termination available
  • Backwards compatible
  • Form factors x4 and x8 standard (including x4 to x8 adaptors)

PCIE® OPTICAL CABLE SYSTEM ÜRÜN SERİLERİ

PCIEO

PCIEO

FLYOVER QSFP28 CABLE SYSTEMS


Samtec’s Flyover QSFP Systems provide improved signal integrity and architectural flexibility by flying critical high-speed signals over lossy PCB materials and directly to the panel via ultra low skew twinax cable. The ultra-high-density design includes sideband signaling via press-fit contacts to help increase airflow, and a multitude of “End 2” options allow for maximum design flexibility.


Flyover QSFP

  • 4 channels (x4 bidirectional, 8 differential pairs)
  • ~100 Gbps NRZ aggregate (~200 Gbps PAM4)
  • Compatible with all QSFP assemblies

Double Density Flyover QSFP

  • 8 channels (x8 bidirectional, 16 differential pairs)
  • ~200 Gbps NRZ aggregate (~400 Gbps PAM4)
  • Belly-to-Belly mating for maximum density
  • Backward compatible with QSFP modules

DIRECT ATTACH


  • One or two rows of contacts directly soldered to the cable
  • Improved signal integrity by eliminating transition board and its variability
  • Achieves tighter tolerances

ULTRA LOW SKEW TWINAX


  • Ideal for 28-56+ Gbps applications
  • Tight coupling between signal conductors
  • Ultra low skew twinax < 3.5 ps/meter
  • Samtec's Flyover Systems

END-2 OPTIONS


  • FireFly™ Micro Flyover System™
  • Direct Connect Systems
  • High-Speed Edge Card Systems
    • 0.80 mm Pitch
    • 0.50 mm Pitch
  • ExaMAX® Backplane Systems